TuYa TS130F
Model | TS130F |
Vendor | TuYa |
Description | Curtain/blind switch |
Exposes | cover (state, position), moving, calibration, motor_reversal, backlight_mode, calibration_time, linkquality |
Picture | ![]() |
White-label | LoraTap SC400 |
Notes
Pairing
Press on stop button for 10 seconds to enter pairing mode
Calibration
- Press the open button on the switch, wait until the curtains are completely open.
- Press the pause button on the switch.
- Put the device into calibration mode, see below.
- Press the close button on the switch, wait until curtains are fully closed.
- Press the pause button on the switch.
- Disable the calibration mode, see below.
Options
invert_cover
: Inverts the cover position, false: open=100,close=0, true: open=0,close=100 (default false). The value must betrue
orfalse
Exposes
Cover
The current state of this cover is in the published state under the state
property (value is OPEN
or CLOSE
). To control this cover publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set
with payload {"state": "OPEN"}
, {"state": "CLOSE"}
, {"state": "STOP"}
. It's not possible to read (/get
) this value. To change the position publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set
with payload {"position": VALUE}
where VALUE
is a number between 0
and 100
.
Moving (enum)
Value can be found in the published state on the moving
property. It's not possible to read (/get
) or write (/set
) this value. The possible values are: UP
, STOP
, DOWN
.
Calibration (binary)
Value can be found in the published state on the calibration
property. To read (/get
) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get
with payload {"calibration": ""}
. To write (/set
) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set
with payload {"calibration": NEW_VALUE}
. If value equals ON
calibration is ON, if OFF
OFF.
Motor_reversal (binary)
Value can be found in the published state on the motor_reversal
property. To read (/get
) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get
with payload {"motor_reversal": ""}
. To write (/set
) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set
with payload {"motor_reversal": NEW_VALUE}
. If value equals ON
motor_reversal is ON, if OFF
OFF.
Backlight_mode (enum)
Value can be found in the published state on the backlight_mode
property. To read (/get
) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get
with payload {"backlight_mode": ""}
. To write (/set
) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set
with payload {"backlight_mode": NEW_VALUE}
. The possible values are: LOW
, MEDIUM
, HIGH
.
Calibration_time (numeric)
Calibration time. Value can be found in the published state on the calibration_time
property. It's not possible to read (/get
) or write (/set
) this value. The unit of this value is S
.
Linkquality (numeric)
Link quality (signal strength). Value can be found in the published state on the linkquality
property. It's not possible to read (/get
) or write (/set
) this value. The minimal value is 0
and the maximum value is 255
. The unit of this value is lqi
.