Hive SLT3
Model | SLT3 |
Vendor | Hive |
Description | Heating thermostat remote control |
Exposes | battery, linkquality |
Picture | ![]() |
Notes
Pairing
To pair the thermostat controller to both Zigbee2MQTT and the thermostat, a factory reset will need to be performed. To begin a factory reset, press and hold both the menu and back buttons together. Allow the countdown to finish before releasing to factory reset the device. After the device has reset and a language has been selected, Zigbee2MQTT should find the device. The device should be able to control the boiler whilst still reporting to Zigbee2MQTT.
Exposes
Battery (numeric)
Remaining battery in %, can take up to 24 hours before reported.. Value can be found in the published state on the battery
property. It's not possible to read (/get
) or write (/set
) this value. The minimal value is 0
and the maximum value is 100
. The unit of this value is %
.
Linkquality (numeric)
Link quality (signal strength). Value can be found in the published state on the linkquality
property. It's not possible to read (/get
) or write (/set
) this value. The minimal value is 0
and the maximum value is 255
. The unit of this value is lqi
.